Product photo retouched for colour and the updated top finish. Fine print texture remains visible.
A draining soap dish for your shower rail. Slide the tray into place, then lift it off for cleaning. No drilling, screws or glue.
Shipping across Europe, calculated by destination before you pay.
Measure the outside diameter of your straight, round shower rail.
Open the integrated hinge, place the clamp sideways around the rail and close it.
The tapered sliding joint draws the clamp halves together. Check the fit without forcing the parts.
Remove the tray vertically to reach the grille and the surface below.
Measure the outside diameter of the straight, round section of your vertical shower rail. Select the clamp with the matching nominal size.
The kit contains five separate sizes. It does not adjust continuously between 19 and 25 mm. It is not suitable for oval, tapered or irregular rails.
Designed and made by DLabs Creation in Belgium. 3D printed in PLA, with a navy blue body and yellow band. Fine print lines are part of the material's finish.
Soap and shower rail are not included. This is a physical product; printing files are not included.
Only use it on a straight, round, vertical rail with an outside diameter matching one of the five included clamp sizes. Measure before ordering; do not force a clamp onto a different size.
The tray slides down into a tapered dovetail joint. As it advances, it draws the clamp halves together. There is no screw, glue, TPU sleeve or spring latch.
We manufacture and dispatch the kit in Belgium. It is in stock for dispatch across Europe. Shipping is calculated by destination before you pay. Returns are covered by our terms.
The product photo has been retouched to match the approved navy colour and corrected top finish. Fine print texture remains visible. The kit illustration and mechanism animation are clearly identified as 3D visuals.
Shipping extra. Check your rail diameter before ordering.
